New Autel IM608 II Programming System is released with firmware update and stronger diagnostic functions. Compared to other Autel Programming Tools (Autel IM608/ IM508/ KM100), what are their differences? Check the Table below: Autel IM608 PRO II/IM608 II/IM608S II… Continue Reading
Problem: To program JLR 2018+ keys, clone key via OBD, choose OEM keys, or replace the whole RFA module or only the chip? Xhorse (VVDI Key Tool Plus) 1.JLR of low specification Add/ AKL via OBD VVDI Remote Clone… Continue Reading
This article is a guide on how to install and activate New KT200 (ktmtool) software. 1.Download Go to https://www.ktmtool.com/. Input Email address and phone number to download software package. Unzip package, click to install software. Then we will have… Continue Reading
Question: If Lonsdor K518ISE is possible to add a key for my 2015 BMW 320i, device can’t communicate with the vehicle The device showed “Communication connection failed. Code: 02” when it was writing original 95128 data. First check if the… Continue Reading
Here we are going to show you how to do odometer correction for Toyota Corolla GLI 2019 with a 100USD Iprog+ Programmer. Original Odometer: Remove the dash and start it. Then we are going to use probe adapters.… Continue Reading
Purpose: Can PCMtuner Tool read/ write Delphi CRD3XX, or other tools you would recommend. 1.PCMtuner CRD3 is not on the support list, but it can be done in Module 53 Tricore BSL to read micro and EEPROM. CRD3.10 and CRD3P… Continue Reading
Question: Is it possible to fix this FoxFlash? I gave power to the programmer from both sides to make it damaged, and now it has no communication with the laptop Regards There is no visible damage on the board. Here… Continue Reading
Here we share the latest V128 IDS software for Ford and Mazda. You could use it with VXDIAG Ford Mazda or other VCIs. Free Download from Cardiagtool: Ford Mazda IDS V128 + Patch Notes: 1)Diagnosis software is not… Continue Reading
Question: GPEC2 ecu in boot, double checked my pin out and the CNF1 with testing but can’t read. Using bench box then remove, in both ways same result. I just think it is locked ecu 2015 plus. Possible for FoxFlash… Continue Reading
Question: Does KT200 work only online? where we could read and write offline? Answer: Yes, KT200 could work offline with KT200 Offline Workstation. *Offline workstation is only compatible with KT200 Full Version (for KT200 Auto Version, pay KT200 Update Service… Continue Reading
