Guide on how to install the crack ODIS-S 4.2.3 on Vxdiag VCX Nano 5054 scanner via USB & Wlan in step-by-step procedure.
Producer: the engineers
Tested on win7 32bit (Also works on WIN 7 64 bits, WIN8 10)
Wlan connection …Yes
Crack ODIS-S 4.2.3 with Vxdiag VCX Nano 5054 test results:
SEAT Bentley …Yes
Output Diagnostic Test Mode…OK
basic setting …OK
coding bus master …OK
measured values …OK
Access authorization …OK
Vxdiag VCX Nano 5054 scanner source:
Crack ODIS-S 4.2.3 source:
Include Keygen and no need to activate
ODIS-S 4.2.3 driver installation and use with Vxdiag nano 5054 via USB & Wlan.
Right click on “VX Manager” and select “Run as administrator”
Tick on “Agree the agreement” and click on “Next”
Tick on “1-Pass Thru and 10-VW”, then “Next”.
VCX Driver Install
Delete “VX Manager”
Open the new icon of “VX Manager”.
Here is VXDIAG Nano VW hardware info.
You can see you get license of PASSTHRU, PDU and VW.
Part 1: How to use VXdiag Nano 5054 via USB connection.
Click on “Configure”, then Connection type “USB” and “Save”.
Exit “VX Manager” and open again, choose “Diagnostic” then “VW ODIS” and “Install”.
Run “VW Audi Skoda Seat ODIS”.
Exit ODIS-S, click on the yellow icon “VW”.
Welcome to Diagnosis, click on “OBD” then “Start self diagnosis”.
Ensure the ignition is on.
Manual select the vehicle info.
Here DTC memory read out.
Go to option “Identification”.
If the ignition is off, you will get the message shown as below.
You can go on do more incl. Output Diagnostic Test Mode, basic setting, coding, coding bus master, measured values, adaptation, Access authorization etc.
Part 2: How to use VXDIAG NANO 5054 via Wlan.
Choose “VCX Wifi” to connect.
Network location is now work, click on “Close”.
Open the yellow icon “Volkswagen” to diagnose.
Repeat the same procedure as the USB connection type to diagnose.