It is about how to install CONDOR XC-MINI cutter and clamp. Hopes it helps.
Note: this post is for CONDOR XC-MINI auto key cutting machine from www.worldobd2.com.
Step 1. Install the cutter
1. Put the cutter into the cutter hole and to the top limit position, ensure the section of cutter and clamp lateral parallel
2. Turn the CUTTER LOCK SCREWclockwise till the cutter is tightened.
Step 2.Removethe Cutter
1. Hold the cutter lightly, Turn the CUTTER LOCK SCREWcounterclockwise
2. After the cutter loosen, remove it.
Step 3. Install the Clamp
1. Turn the LOCKING WRENCH counterclockwise on the left side to loosen.
2. Choose the clamp according to the key type, Push the clamp from the right side of the LAMP CARRIAGE to limit position
3. Turn the LOCKING WRENCH clockwise to tighten the clamp.