When I install the newest scania vci3 software V2.44.1, an error message suddenly pops up “No valid key could be found. To start SDP3 with limited functionality, select the Without key option. For troubleshooting or demo mode, a valid software key must be installed. Select the software key option or use a USB key and select the USB key option.”
Caused the error reason:
Patch is not installed
Solution offered by cardiagtool.co.uk engineer:
Scania SDP3 2.44.1 download link (Chinese weiyun):
Size: 953.56 MB
SDP3 2.44.1 download link (Mega):
Source: mhh forum (credits to @ JOSE BRENO)
Operating system: Windows 7 or Win10 32 bit/64 bit
When finish installing Scania Diagnos & Programmer 3 2.44.1 setup
Right click on “Prereqset64v3” and select “Run as administrator“.
Restart the computer.
Right click on “Computer” and choose “Properties” to view the computer system is 32bit or 64bit.
Back to open Computer -> Local Disk (C:) -> KeyGenandFIX->X32 or X64 -> install device driver
SDP3 2.44.1 activation service:
Open KeyGenandFIX folder->Hardware ID Reader-> SDP3 HWID reader x86 (public)
Copy Hardware ID and send to your dealer to active
After you receive the activation file from your dealer, right click on “Registry Editor” and select “Merge”, then “Yes”.
Open Local Disk (C:)->KeyGenandFix -> Fix File 2.44.1.
Copy the .dat and .dll files.
Right click on “SDP3” on the desktop
Select “Properties”-> “Open File location”-> then “Paste” (Paste the two.dat and .dll files above to replace the existing ones).
Open Local Disk (C:)->KeyGenandFix.
Open “Time” and click on “Crack”
Please refer to the video of Scania SDP3 2.43.01 installation guide:
SDP3 Patch+ crack time: start from 5:16