Problem 1:
going to program my FRM using winKFP and i got this error: Error 201 on flash programming!
Solution:
check your winKFP configuration
make sure it looks like this:
Error 211 was because i didn’t have the power supply connected with the right Volts.
Problem 2:
Error 106: Error on setting ECU Adress.
Solution:
Choose confort mode enter zub. mine was 9204527 for frm2 then I enter vin click ok then zub update click done after that send me to other window and I hit prog.zub update and program successful! Then exit winkfp.
Then, FRM is programmed.