One customer gave feedback that he cannot connect MED9.1 on bench. Bench box with stable PSU, and tried all pinouts but FoxFlash Tool will not read ECU. Solution: Step 1. Disconnect BDM Adapter!! put 12V in FoxFlash not bench box… Continue Reading
Question: FoxFlash Programmer incorrectly identifies the software number of Toyota Hilux. Such a number (30K89200) for software designation of Toyota control units does not exist. How to select correct firmware from this data? Here Cardiagtool tech answer: ID is correct.… Continue Reading
One customer wondered if FoxFlash ECU Programmer supports VGS3 cloning, is it possible? It will need also Vediamo programming or just clone and run? Answer: Yes, clone and run. What FoxFlash does is to copy the VIN and SCN string… Continue Reading
One customer wonders if it is safe to use extension cable (DB15 Male to Female) to connect FoxFlash Main Unit and bench box. Here FoxFlash engineer answers: Not recommended. If you have to, the extension cable should be as short… Continue Reading
Question: Original FoxFlash, possible to read Fiat IAW 10GF? only 10GF on the support list? PINOUT: Connection: Run FoxFlash software, Go to FIAT>>MARELLI ECU>>1.2 8V IAW 9GF FULL SYSTEM *CAN Click Load File to load IMMO Off file. Write.… Continue Reading
FoxFlash/ New KT200 ECU Tool supports MEDC17/ EDC17 free clone service. Here we are going to show you the steps of this function and its support list in Original FoxFlash/ KT200. Part 1.How to Perfect Clone MED/EDC17? Tools: New KT200… Continue Reading
Question: Is it possible for Original FoxFlash to unlock PCR2.1 with all done by OBD without removing ecu. Generally we need to remove ecu, unlock it, switch chip into BSL mode, then install back and read/ write via OBD.… Continue Reading
FoxFlash ECU Tool updates its functions on VAG TCU, Toyota Gen1, BMW MSV90, etc. in January. *Connect to the Internet, everything will synchronize automatically 1.Bench Mode TRICORE TC1782 With this update you will be able to fully read and write:… Continue Reading
FoxFlash is good at R/W DCU-10x Fiat/ Ford/ Peugeot/ Citroen by BOOT mode. Here is a review of Ford DCU: DCU 101 Ford Transit 2.2 d FoxFlash reading uploading checksum program Ok EGR off Tools: FoxFlash Hardware 1,000 ohm resistor*2… Continue Reading
Question: FoxFlash read Opel Delco E98 ID and Flash without problem but app crashed when reading EEPROM and Backup. So, is FoxFlash Tool possible to work on the real challenge Delco E98? Yes, Flash+ EEPROM read/write. Here are some… Continue Reading
