One customer asked us what tools would clone Opel PSG16, Bench only or possible OBD. So, here we are going to share with you top 3 tools to clone this module. 1.FoxFlash Original FoxFlash support PSG16 below: Opel Astra… Continue Reading
In this article, we have collected FAQs about V1.3.6 FoxFlash Special Customized Version. V.1.3.6 Update Info: 1: Improve all VR databases. 2: Personal equipment customization. 3: Customize your brand tuning logo into the tool software (order from seller via the… Continue Reading
FoxFlash is good at R/W DCU-10x Fiat/ Ford/ Peugeot/ Citroen by BOOT mode. Here is a review of Ford DCU: DCU 101 Ford Transit 2.2 d FoxFlash reading uploading checksum program Ok EGR off Tools: FoxFlash Hardware 1,000 ohm resistor*2… Continue Reading
Question: FoxFlash read Opel Delco E98 ID and Flash without problem but app crashed when reading EEPROM and Backup. So, is FoxFlash Tool possible to work on the real challenge Delco E98? Yes, Flash+ EEPROM read/write. Here are some… Continue Reading
One customer had a problem with BMW EDC17CP02 CP06 on bench. With every pin connected and bench box powered, FoxFlash Hardware can’t read. Here Cardiagtool tech shares the Solution: 1.Repin ECU with alternate pinout(2 types) 2.Switch off MFC until commanded… Continue Reading
Is FoxFlash possible to read EDC17CP54? One customer gave feedback that his FoxFlash can’t read it. Besides, all cable connection is fine he had checked. Here is the Solution: 1.Pin 50 on the central row +12v Not pin 33 +12V… Continue Reading
One customer gave feedback: FoxFlash did not read PSA Mev17.4 on Bench, with 12v and 13.5v. If MEV17.4 TC1766 Peugeot could be read with PCMtuner? Answer: Both work but there are 3 possible pinouts. Confirm the wires of terminals are… Continue Reading
Question: SID309 OBD password unlock stop at 57%. Waited for 20 minutes and nothing was happening. How to make FoxFlash Software continue? Here Cardiagtool tech Answer: When reading password via OBD (IN CAR) please ensure immo system does not become… Continue Reading
Question: Can FoxFlash read/ write gpec2? Here Cardiagtool tech Answer: FoxFlash Software support GPEC2A, GPEC3, GPEC4, GPEC4LM but not GPEC2. Here is all supported GPEC PCM: Brand vehicle Model vehicle Engine/gear type ECU Brand ECU Type Info Micro Info EEPROM… Continue Reading
The latest V1.3.0 FoxFlash Manager could support up to 6 computers, which allows you run FoxFlash software on different computers without activation. If you still don’t know how to install and activate FoxFlash, please check: Free Download FoxFlash Software… Continue Reading
