Benz Diagnostic Tool
How to export HU05 control module data and program by VXDIAG Benz C6 with DTS Monaco software? Check the step-by-step guide in this post. Connect Star C6 with the vehicle Run DTS Monaco software HU5 Ethernet option cannot be found in… Continue Reading
Customer problem: When I run 2020.03 MB SD C4 Plus software, an error message pops up with the words “Register/Configure (2138) The key is not divisible by 2 and therefore not hexadecimal”. Cardiagtool.co.uk engineer replied: 1.Please remove the tick of WLAN parameters, workshop… Continue Reading
When installing DTS Monaco to communicates and works with SD connect c4 all user installed SDconnect Toolkit version 2.1.3. And no one tried to force the work SDconnect Toolkit version 2.1.4.2, which is installed together with the installation of Setup_Addon_DAG. And I did it.… Continue Reading
It is of value to people looking for a MB system diagnosis system. I myself have been looking and researching for two months and have concluded that the multiplexer to purchase is the newer style unit. After 2015, all… Continue Reading
Check what MB SD C4 Plus can do or cannot do from the customer feedbacks and frequently asked questions. Here are some test reports about MB SD C4 PLUS can or cannot work: W164 ML 6.3amg 2006 diagnosis- OK… Continue Reading
Car model and year: ’99 CLK 320 Coupe Purpose: a comprehensive scan tool or laptop based software about $500 Optional W208 Scanner: It wasn’t very long ago that the only choice was the MB STAR diagnostic software (a.k.a SDS), that cost $xx,xxx… Continue Reading
Customer problem: After the 03.2020 MB SD C4 Xentry software updates automatically, I couldn’t login. And a fault message pops up with the words “The data are faulty”. Now I cannot do anything. How to solve? Solution from cardiagtool.co.uk engineer: The… Continue Reading
BENZ ECOM DOIP comes with USB Dongle can support diagnosis and programming for latest Mercedes-Benz till year 2019. Here is test report on Benz E320L. Preparation: Car: Mercedes-Benz E320L Device: Benz ECOM DOIP with Xentry software Procedures: Follow this connection diagram… Continue Reading
MB SD C4 Plus DOIP WiFi connection problem: An error message prompts as shown in the following picture. And there is something wrong with the WIFI. Is possible to use LAN cable to connect? Solution Advice: There are two connection methods… Continue Reading
Customer Problem: When i connected SD Connect C4 with my computer, it showed white 00 connection status at the bottom right corner. A message prompted “Initialization of diagnosis multiplexer failed.” Do i need to initialize the device? Cardiagtool.co.uk engineer solution: The prompt indicates that… Continue Reading
