New FoxFlash OTB 1.0 Adapter is coming! It works with engine, TCU, ACM, and DCM module. It allows to read data on OBD mode using Bench pinouts. Supported functions: 1.Dual-channel high-speed CAN 2.Three-way BOOT 3.Dual VCC power supply 4.GPT encryption… Continue Reading
Original FoxFlash ECU Programmer newly add Delco Bosch Siemens Phoenix Tuning and New Clone Function for MEDC17! New Clone Function Info: MEDC17 FCA HYUNDAI JAGUAR LAND ROVER SUZUKI TOYOTA ECU List BENCH Delco E38 E67 E84 E92 BOSCH… Continue Reading
OBD unlock patch GPEC2 GPEC2A is ready in Original FoxFlash Programmer. Supported GPEC2 & GPEC2A: Jeep 2.4 Tigershark 184 hp Jeep 3.2 Pentastar V6 275 hp Jeep / Lancia 3.6 Pentastar V6 285 hp Dodge 3.6 Pentastar V6 292 hp… Continue Reading
In this article, we have collected FAQs about V1.3.6 FoxFlash Special Customized Version. V.1.3.6 Update Info: 1: Improve all VR databases. 2: Personal equipment customization. 3: Customize your brand tuning logo into the tool software (order from seller via the… Continue Reading
One customer gave feedback that he cannot connect MED9.1 on bench. Bench box with stable PSU, and tried all pinouts but FoxFlash Tool will not read ECU. Solution: Step 1. Disconnect BDM Adapter!! put 12V in FoxFlash not bench box… Continue Reading
Question: FoxFlash Programmer incorrectly identifies the software number of Toyota Hilux. Such a number (30K89200) for software designation of Toyota control units does not exist. How to select correct firmware from this data? Here Cardiagtool tech answer: ID is correct.… Continue Reading
One customer wondered if FoxFlash ECU Programmer supports VGS3 cloning, is it possible? It will need also Vediamo programming or just clone and run? Answer: Yes, clone and run. What FoxFlash does is to copy the VIN and SCN string… Continue Reading
One customer wonders if it is safe to use extension cable (DB15 Male to Female) to connect FoxFlash Main Unit and bench box. Here FoxFlash engineer answers: Not recommended. If you have to, the extension cable should be as short… Continue Reading
Question: Original FoxFlash, possible to read Fiat IAW 10GF? only 10GF on the support list? PINOUT: Connection: Run FoxFlash software, Go to FIAT>>MARELLI ECU>>1.2 8V IAW 9GF FULL SYSTEM *CAN Click Load File to load IMMO Off file. Write.… Continue Reading
Question: Is it possible for Original FoxFlash to unlock PCR2.1 with all done by OBD without removing ecu. Generally we need to remove ecu, unlock it, switch chip into BSL mode, then install back and read/ write via OBD.… Continue Reading
