One customer gave feedback that he cannot connect MED9.1 on bench. Bench box with stable PSU, and tried all pinouts but FoxFlash Tool will not read ECU. Solution: Step 1. Disconnect BDM Adapter!! put 12V in FoxFlash not bench box… Continue Reading
Question: FoxFlash Programmer incorrectly identifies the software number of Toyota Hilux. Such a number (30K89200) for software designation of Toyota control units does not exist. How to select correct firmware from this data? Here Cardiagtool tech answer: ID is correct.… Continue Reading
Here we are going to share with you some ECU tuning software and files, hope they could work with your ECU Tools perfectly File List: Damos File Pack 2020 Immo Killer V1.1 ECM Titanium V1.61 Car Tool Software V1.06 … Continue Reading
CG FC200 is a good choice for ECU programming, especially for Bosch ECU. Here is a review of backuping a broken Bosch ECU: Back up a broken and shorted MED17.5.25 from a VW Tiguan 2018/2019 Success. All 6 power and… Continue Reading
One customer wondered if FoxFlash ECU Programmer supports VGS3 cloning, is it possible? It will need also Vediamo programming or just clone and run? Answer: Yes, clone and run. What FoxFlash does is to copy the VIN and SCN string… Continue Reading
One customer wonders if it is safe to use extension cable (DB15 Male to Female) to connect FoxFlash Main Unit and bench box. Here FoxFlash engineer answers: Not recommended. If you have to, the extension cable should be as short… Continue Reading
Question: Original FoxFlash, possible to read Fiat IAW 10GF? only 10GF on the support list? PINOUT: Connection: Run FoxFlash software, Go to FIAT>>MARELLI ECU>>1.2 8V IAW 9GF FULL SYSTEM *CAN Click Load File to load IMMO Off file. Write.… Continue Reading
Question: Is it possible for Original FoxFlash to unlock PCR2.1 with all done by OBD without removing ecu. Generally we need to remove ecu, unlock it, switch chip into BSL mode, then install back and read/ write via OBD.… Continue Reading
FoxFlash is good at R/W DCU-10x Fiat/ Ford/ Peugeot/ Citroen by BOOT mode. Here is a review of Ford DCU: DCU 101 Ford Transit 2.2 d FoxFlash reading uploading checksum program Ok EGR off Tools: FoxFlash Hardware 1,000 ohm resistor*2… Continue Reading
Question: FoxFlash read Opel Delco E98 ID and Flash without problem but app crashed when reading EEPROM and Backup. So, is FoxFlash Tool possible to work on the real challenge Delco E98? Yes, Flash+ EEPROM read/write. Here are some… Continue Reading
