One customer wondered if KT200 Programmer can read/ write PSA DCM6.2A in bank? Or can only do it in OBD Answer: On Bench/ OBD on Bench/ Jtag BDM. Method 1.On Bench PIN2&3&52 – +12V PIN4&5 – GND PIN33 –… Continue Reading
Question: Can FoxFlash read/ write gpec2? Here Cardiagtool tech Answer: FoxFlash Software support GPEC2A, GPEC3, GPEC4, GPEC4LM but not GPEC2. Here is all supported GPEC PCM: Brand vehicle Model vehicle Engine/gear type ECU Brand ECU Type Info Micro Info EEPROM… Continue Reading
One user gave feedback that his KT200 Full License showed ERROR SET2 when reading PSA EDC16C3. Here Cardiagtool tech gave the Solution: Remove the resistor, which is built into the bench box. Same connection only the resistor is not required.… Continue Reading
The latest V1.3.0 FoxFlash Manager could support up to 6 computers, which allows you run FoxFlash software on different computers without activation. If you still don’t know how to install and activate FoxFlash, please check: Free Download FoxFlash Software… Continue Reading
One customer wonder if KT200 Tool could read calculator Sim32 Clio 3 1.2 on the table by obd with godiag cable? Answer: Test, if not work, do gateway/ immo clearance. KT200 only support SIM32 on BDM/ JTAG mode. … Continue Reading
One customer wonders if it’s possible to read that ecu since its KT200 can’t read it. Valeo VD46. Answer: VD46 is different from V46, the processor is SH725 and no driver supports. Difference between VD46 and V46: 1.VD46… Continue Reading
Here we are going to show you how to download and install FoxFlash Software step by step. Free Download FoxFlash Software: FoxFlash Manager (Main Software: Download via “FoxFlash Manager” after activation) Operating System: Windows 7/ 8/ 8.1/ 10/ 11… Continue Reading
One customer wondered why his PCMtuner V1.27 module 71 bench mode still won’t work and he had changed the transistors as guides. Here is a Possible Solution: Go to “Settings” on PCMtuner 1.27 Program. Disable “Use other GPT outputs… Continue Reading
When you use KT200/KTM200 to perform ECU maintenance chip tuning, DTC code removal on BOSCH, MAGNETI MARELLI, CONTINENTAL, Denso, DELCO, TEMIC or SIEMENS by bench, boot, BDM/JTAG and OBD mode, you’d better install KT200 software V22.08.20 on Win10 32/64bit with Intel i5,… Continue Reading
Fetrotech Tool Use Guide: Software Download, Installation, Registration and Activation. Before Installing the software,please connect one end of the device to the power supply and the other end to the comptuer. please refer to the diagram for connection method. Fetrotech… Continue Reading
