Sometimes we may lose coding of BMW BDC2 when we try to add keys. If so, we can fix this using ACDP Module 38. Here are the steps: Connect ACDP to BDC2 unit using module 38. Select ‘Identify vehicle… Continue Reading
New AutoTuner Protocol is released on 20 July, 2025! New release for Siemens MSS70 and MSV70 ECUs, now supported in OBD mode for BMW vehicles! This protocol introduces automatic detection of our patch, drastically reducing writing time: once the ECU is patched, you go from around… Continue Reading
Launch adds BMW G-Series BDC2 function on its IMMO tablets For Free. Here we are going to show you how to do it. Tools: Launch IMMO Tablet or Launch Diagnostic Tablet with IMMO License Launch X-PROG3 Launch MCU Adapter… Continue Reading
One customer wonders how is PADFLASH for Mercedes CRD3.10? Here are our tests by Bench& OBD mode. 1)OBD Run PADFLASH software. Select Mercedes>>C KLASSE (from 2010)>>1.8/2.2 CDI Blue 136/177/204HP Delphi CRD3.X CAN Fast (TC1797) Connect PADFLASH to CRD3.10 as required.… Continue Reading
Here is a review of OBDSTAR DC706 ECU Tool: Chevy Cruze >> SIMTEC76.1 ECU info Bench mode connect for R&W flash not working Adapter Supply 14&15 V Boot Mode working Let’s check out how it is done. Read ECU… Continue Reading
Here we have an affordable tool that will add key for BMW G-Series BDC2 system – CGDI A2 Full Version. Let’s check out how it did the job. Turn on CGDI A2. Select BMW V1.03>>System selection>>BDC Immobilizer (G chassis) 1.Back… Continue Reading
This article will show you how to add key for BMW G-Series X3 using Autel IM508/ IM608. Tools: Autel IM608 II (with Autel License for BMW G-Series BDC2 Add Key) Autel BMW Key Guide: On tablet Select IMMO>>BWW>>Smart… Continue Reading
Launch CANFD Cable allows Launch CRP919 BT to diagnose CANFD protocol cars. This cable also works with other Launch Creader Series Tablets. Here we will show you how. Guide: Disconnect CANFD cable. Connect it to OBD cable and port.… Continue Reading
Question: OBDSTAR G3 or OBDSTAR DC706 having issues with the OBDSTAR TCM-019 Cable. I’ve tried on 4 different transmissions and I can’t get it to read anything at all. Have the same problem with the TCM-025 ZF 8HP Connectors. Here… Continue Reading
AutoTuner new release for Getrag 7DCT300 TCUs, now supported in OBD mode for Alpine, Dacia, Nissan, and Renault vehicles! This new protocol allows virtual reading (VR) and fast writing directly through the OBD port, without opening or disassembling anything. It… Continue Reading
