Alitentech KESS3 V1.88 is released! Bosch MG1UA008/ MD1CS018/ EDC17C69/ MEG17.9.77/ ME17.9.21.1/ MG1US008/ MED17.8.21/ ME17.9.56 are added. Check out the latest updates, and make sure your KESS3 subscription is active. New ECUs: Bosch MG1UA008 DSFK MOTOR -RD, WR in Bench Mode… Continue Reading
Autel Ultra Lite, the car is Mercedes C63 2008 (w204). I tried to program new ECU (MED9.7) and during the flash I got write error. After that I managed to flash if with a different tool but then I got… Continue Reading
One customer asked where is the ADAS menu in his Launch X431 VII Elite. Have activated ADAS software from backstage but the tablet still asks for activation. So, here are something you need to know about Launch X431 ADAS License.… Continue Reading
One customers asked about the difference between Launch X431 PAD V Elite and Launch X431 PAD VII Elite. Generally, PAD VII Elite has better firmware than PAD V Elite; there are no difference in software. X431 PAD V Elite… Continue Reading
This article will show you how to install Alientech Kess3 software. How to Install KESS V3 Software? Go to Alientech official website: https://www.alientech-tools.com/download/. Download Alientech Suite. Open AlientechSuite_Setup. Install Alientech suite. Run Alientech-Suite.exe. Download new software version. Click OK to… Continue Reading
Alitentech KESS3 V1.87 is released! DCU15C167 SID605 EDC16C8 MD1CC898 for HD Vehicles are added. Check out the latest updates, make sure your KESS3 subscription is active. New ECUs: Bosch DCU15C167 YUTONG – RD, WR and Clone in Boot Mode… Continue Reading
Quick Question: I have an Autel MS909 Tablet with Autel ADAS License, and I keep getting vehicle’s with pre-scan report. How do I get past this screen with report status enabled in settings when performing an ADAS calibration? And what… Continue Reading
Alitentech KESS3 V1.86 upgrade is released! Magneti Marelli MM10JA and IAW 11GF by Bench Mode are added. Check out update info, all KESS3 with an active subscription will enjoy the update! New ECUs: Magneti Marelli MM10JA Alfa Romeo -RD, WR… Continue Reading
Quick Question: Does X431 PAD VII Elite supports online programming? Is there a support list for that, and if there is IP restriction on online programming software. Vehicle Software and Language List: Vehicle Language Area IP Restriction Ford Simplified Chinese… Continue Reading
Quick Question: Cloned a Simos 8.51 module ( 2013 Audi A8 ctub) with the Launch X431 Xprog3? I had successfully backed up the eeprom and flash from the original ECU and loaded it into the donor but the vehicle does… Continue Reading
