FoxFlash is good at R/W DCU-10x Fiat/ Ford/ Peugeot/ Citroen by BOOT mode. Here is a review of Ford DCU: DCU 101 Ford Transit 2.2 d FoxFlash reading uploading checksum program Ok EGR off Tools: FoxFlash Hardware 1,000 ohm resistor*2… Continue Reading
Autel IM508/ IM608PRO is good at Programming Volvo when all key lost before 2018 . This article is a review of Autel IM608 PRO on Volvo: 2018 VOLVO V40 all key lost by OBD Autel IM608 no problem Take… Continue Reading
Question: FoxFlash read Opel Delco E98 ID and Flash without problem but app crashed when reading EEPROM and Backup. So, is FoxFlash Tool possible to work on the real challenge Delco E98? Yes, Flash+ EEPROM read/write. Here are some… Continue Reading
One customer had a problem with BMW EDC17CP02 CP06 on bench. With every pin connected and bench box powered, FoxFlash Hardware can’t read. Here Cardiagtool tech shares the Solution: 1.Repin ECU with alternate pinout(2 types) 2.Switch off MFC until commanded… Continue Reading
New Autel IM608 II Programming System is released with firmware update and stronger diagnostic functions. Compared to other Autel Programming Tools (Autel IM608/ IM508/ KM100), what are their differences? Check the Table below: Autel IM608 PRO II/IM608 II/IM608S II… Continue Reading
Problem: To program JLR 2018+ keys, clone key via OBD, choose OEM keys, or replace the whole RFA module or only the chip? Xhorse (VVDI Key Tool Plus) 1.JLR of low specification Add/ AKL via OBD VVDI Remote Clone… Continue Reading
This article is a guide on how to install and activate New KT200 (ktmtool) software. 1.Download Go to https://www.ktmtool.com/. Input Email address and phone number to download software package. Unzip package, click to install software. Then we will have… Continue Reading
Question: If Lonsdor K518ISE is possible to add a key for my 2015 BMW 320i, device can’t communicate with the vehicle The device showed “Communication connection failed. Code: 02” when it was writing original 95128 data. First check if the… Continue Reading
Here we are going to show you how to do odometer correction for Toyota Corolla GLI 2019 with a 100USD Iprog+ Programmer. Original Odometer: Remove the dash and start it. Then we are going to use probe adapters.… Continue Reading
Purpose: Can PCMtuner Tool read/ write Delphi CRD3XX, or other tools you would recommend. 1.PCMtuner CRD3 is not on the support list, but it can be done in Module 53 Tricore BSL to read micro and EEPROM. CRD3.10 and CRD3P… Continue Reading
